How to Replace the Blade on a Porter Cable Biscuit Joiner

Many of us use our biscuit joiner daily, others on a weekly or monthly basis, however no matter your frequency of use, eventually, you will need to exchange its cutting tool. A sharp blade retains your joiner fast, successful and precise so when their power tools have these qualities, usually the crafter behind it does too. Fortunately for us crafters, then, replacing the blade over a Porter Cable biscuit joiner is a relatively simple process. Despite a slightly more complicated chip deflector and lock flag, changing your Porter Wire biscuit joiner blade requires bit more than a few minutes, a screwdriver and an Allen wrench.

As with all power tool repair procedures, the first step in changing your joiner blade is disengaging and unplugging the tool. Next, simply flip the tool over and ease the screws in the bottom plate. Your Porter Cable biscuit joiner should have four screws also because this tool also features tapered screw holes, you will not need to totally remove the screws to remove the platter; instead you can simply slide the plate off (slide the plate towards the bottom of the tool and lift to remove). This specific, of course , gives you entry to the blade.

Image result for biscuit-joiners

Hold out! Before grabbing 9 reviews at the blade, though, you must depress the lock pin. The lock pin on Porter Cable biscuit joiners is at the top front of the tool (more-or-less) beneath the handle. Demanding this pin prevents the blade from spinning allowing users to safely remove it. The trick, though, is that the lock pin must be depressed constantly as you remove the blade and that the blade must be removed with an Allen wrench. So, while depressing the locking pin with your secondary hand, use your major hand to insert your Allen wrench in to the centre of the blade bolt, loosen and remove it. Carefully remove the blade.

Immediately beneath the blade, the Porter Cable biscuit joiner comes with an adjustable chip deflector. This mechanism allows the tool to accommodate both standard sized blades and smaller face-frame blades. Based after the dimensions of the new blade you've put onto the joiner, you may now need to adapt the chip deflector. With regard to standard sized blades, this swiveling mechanism should stay in the horizontal (left - right) position (or, more-or-less parallel to the directional arrow stamped above it). If, however, you installed a smaller blade, you should have to pull the engine forward to release it and shift the chip deflector to a up and down position (so that it now points to the front of the tool and crisscrosses with that directional arrow).

Next, you must install the new joiner blade. The blade will have a similar directional arrow printed on the surface. This arrow is designed to ensure users install the cutting tool with its teeth facing the right direction. Install the blade so that its arrow points in the same direction as the directional arrow on the tool. Pop the cutting tool into place and and replace the washer and bolt. While depressing the lock pin tighten the bolt over the cutting tool.

After securing the cutting tool, you need only glide underneath plate back into place and tighten down the four screws that keep it there. Which is exactly that. Give yourself a pat on the back and know that your Porter Cable biscuit joiner is now as good to go as you are.

Joining M&M Tool and Machinery and ToolsandMachinery. com in December of 2006, Mallory has refined the woman expertise in power tool elements, tool repair and many more aspects of the woodworking and production industries. Her hands-on experience with woodworking machinery, power tools and strength tool parts ensure her knowledge is current, and her solid relationships with major factory representatives and M&M's own staff of experienced crafters and technicians ensure her wit and info remain sharp. - Offering the most extensive inventory of power tools, replacement parts, machinery and accessories, ToolsandMachinery. com is the ultimate resource for your woodworking, crafting, DO-IT-YOURSELF, and construction needs.

Views: 7

Comment

You need to be a member of South Beach Singles to add comments!

Join South Beach Singles

© 2019   Created by SOUTH BEACH SINGLES.   Powered by

Badges  |  Report an Issue  |  Terms of Service